Laser Hair Removal Info
by K Bills


Laser hair removal was performed experimentally for about 20 years before it became commercially available in the mid 1990s. Laser and light-based methods are sometimes called phototricholysis or photoepilation.

In addition to lasers, some light-based epilators use a xenon flashlamp which emits full-spectrum intense pulsed light (IPL).

The primary principle behind laser hair removal is selective photothermolysis. Lasers can cause localized damage by selectively heating dark target matter in the area that causes hair growth while not heating the rest of the skin. Light is absorbed by dark objects, so laser energy can be absorbed by dark material in the skin (but with much more speed and intensity). This dark target matter, or chromophore, can be naturally-occurring or artificially introduced.

Hair removal lasers selectively targets one of three chromophores:

* Carbon, which is introduced into the hair follicle by rubbing a carbon-based lotion into the skin following waxing (this lotion is an "exogenous chromophore"). When irradiated by a Q-switched Nd:YAG laser, the carbon causes a shock wave capable of mechanically damaging nearby cells. This method has been abandoned since it does not cause permanent loss. (It has been replaced with the long-pulsed Nd:YAG laser which targets endogenous melanin in the follicle.)

* Hemoglobin, which occurs naturally in blood (it gives blood its red color). It preferentially absorbs wavelengths from argons, and to a lesser extent from rubies, alexandrites, and diodes. It minimally absorbs the Nd:YAG laser wavelength. Hemoglobin is not a primary target for laser hair removal.

* Melanin is considered the primary chromophore for all hair removal lasers currently on the market. Melanin occurs naturally in the skin (it gives skin and hair its color). There are two types of melanin in hair: eumelanin (which gives hair brown or black color) and pheomelanin (which gives hair blonde or red color). Because of the selective absorption of photons of laser light, only black or brown hair can be removed.

Laser parameters that affect Laser Hair Removal results

Several wavelengths of laser energy have been used for hair removal, from visible light to near-infrared radiation. These lasers are usually defined by the lasing medium used to create the wavelength (measured in nanometers (nm)):

* Argon: 488 or 514.5 nm * Ruby: 694 nm * Alexandrite: 755 nm * Pulsed diode array: 810 nm * Nd:YAG: 1064 nm

Pulsewidth is an important consideration. It has been observed in some published studies that longer pulsewidths are safer in darker skin.

Spot size, or the width of the laser beam, affects treatment. Theoretically, the width of the ideal beam is about four times as wide as the target is deep. Most lasers have a round spot about the size of your little finger (8-10 mm).

Fluence or energy level is another important consideration. Fluence is measured in joules per square centimeter (J/cm2).

Repetition rate is believed to have a cumulative effect, based on the concept of thermal relaxation time. Shooting two or three pulses at the same target with a specific delay between pulses can cause a slight improvement in the heating of an area.

Epidermal cooling has been determined to allow higher fluences and reduce pain and side effects, especially in darker skin.

Four types of cooling have been developed:

* Clear gel: usually chilled * Contact cooling: through a window cooled by circulating water * Cryogen spray: immediately before/after the laser pulse * Air cooling: forced cold air at -34 degrees C (Zimmer Cryo 5 unit)

Multiple treatments have been shown in numerous studies to be more effective for long-term reduction of hair. Current parameters suggest a series of treatments spaced at 1 month for the face, 2 months for the chest and 3 months for the legs.

Other uses

Hair removal lasers are effective treatment for pseudofolliculitis barbae (commonly called ingrown hairs or "shaving bumps"). For darker skin patients with black hair, the long-pulsed Nd:YAG laser with a cooling tip can be safe and effective when used by an experienced practitioner.

They have recently been reported as helpful treatment for pilonidal cysts, since they eliminate the ingrown hairs that produce the troublesome foreign body reactions in this congenital malady.

More info here: Laser Hair Removal